TopHat Screw On Bullet Nose Brass Field Points, 6-packItem Number: 0934X
$8.50 $8.50
TopHat® Archery does it again with their brass bullet nose screw-on points. Easy to install on your wood arrows, and easy to remove from targets due to the convex design.
The brass material is softer and more forgiving than other metals, which decreases the possibility of damage on the arrow. The arrow point is threaded onto the blunt shaft (no glue or taper required). The thread inside the arrow point attaches firmly to the shaft, making accidental loosening impossible.
Available in 5/16" - 70, 100, and 125 grains, and 11/32" - 80, 100, and 125 grains. Please specify. Sold by the 6 pack.
Please note: It is recommended that you buy the TopHat® Thread Cutting Tool, TopHat® Shaft Shaper, and TopHat® Assembly Tool to use with these points.
The TopHat® ThreadCutting Tool is for starting a thread onto the shaft to make it easier to install Screw-On points. The TopHat® Shaft Shaper is for compressing down an oversized shaft so the finish will not be marred when installing points, and to allow the points to go on easier. The TopHat® Assembly Tool is for gripping the point, the Thread Cutting Tool and The Shaft Shaper without marring them for easy tightening and removal of TopHat® points.
The brass material is softer and more forgiving than other metals, which decreases the possibility of damage on the arrow. The arrow point is threaded onto the blunt shaft (no glue or taper required). The thread inside the arrow point attaches firmly to the shaft, making accidental loosening impossible.
Available in 5/16" - 70, 100, and 125 grains, and 11/32" - 80, 100, and 125 grains. Please specify. Sold by the 6 pack.
Please note: It is recommended that you buy the TopHat® Thread Cutting Tool, TopHat® Shaft Shaper, and TopHat® Assembly Tool to use with these points.
The TopHat® ThreadCutting Tool is for starting a thread onto the shaft to make it easier to install Screw-On points. The TopHat® Shaft Shaper is for compressing down an oversized shaft so the finish will not be marred when installing points, and to allow the points to go on easier. The TopHat® Assembly Tool is for gripping the point, the Thread Cutting Tool and The Shaft Shaper without marring them for easy tightening and removal of TopHat® points.
Get the Newsletter
