An arrow in flight is beautiful to behold. 3Rivers Firefly Wooden Arrows are the perfect example of this. With their bright, colorful fletchings, stunning cresting, and quality port orford cedar, it's like shooting a work of art.
Firefly arrows are gasket lacquer sealed, not stained, so you preserve the natural beauty of the port orford cedar. All arrows are hand dipped and hand crested, for the kind of detail and craftsmanship traditional archers crave. We use 11/32" diameter shafts (30-35# are 5/16") to create these magnificent arrows.
3Rivers Archery® has 3-fletched these beautiful arrows with 5" left wing shield cut feather fletches, two solid lime and one lime barred. We've added classic florescent green nocks for even more otherworldly beauty.
Available in spines of 30-35 (5/16"), 35-40, 40-45, 45-50, 50-55, 55-60, 60-65, and 65-70. Weight matched to groups of 20 grains.
Sold full length at approximately 32" and need to be cut and tapered, then pointsinstalled or broadheads mounted to be ready for shooting. Please remember, when having points or broadheads installed they must be purchased separately.
We offer a straightening service for wood arrows, but these arrows are not hand straightened before they leave the warehouse. Our arrows are hand-spined because we feel that is the key to good arrow flight. They are not weight matched.
Not sure which size to order? See our Arrow Spine Selection Chart.
PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.
Services Available
Cut and Taper Arrows to Length: Have your wood arrows cut to length and a 5° point taper. The length is measured from the throat of the nock to the back of the point taper. Minimum length is 26".
Mount Field Points: Choose this option to have our experts install your Target/Field Point on your arrows. Points sold separately. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to even length (if any variance between arrows), and the point taper applied. Please Note: We use a heat reversible glue to mount field points, so they may be changed later if you choose.
See Printable Shaft Selection Chart PDF
Get the Newsletter
